To save a tape permanently
To prevent a tape from being accidentally recorded over, break off the cassette tab from side A or B as illustrated.
If you later want to reuse the tape for recording, cover the broken tab with adhesive tape. However, be careful not to cover the detector slots which allow the tape player to automatically detect the type of tape.
|
| Detector slots |
Tab of side B | Tab of side A | |
| Tape type: | Tape type: |
| CrO2/METAL | Normal |
Detector slots
Break off the cassette tab of side A
Before placing a cassette in the tape deck
Take up any slack in the tape. Otherwise the tape may get entangled in the parts of the tape deck and become damaged.
When using a tape longer than 90 minutes
The tape is very elastic. Do not change the tape operations such as play, stop, and
Cleaning the tape heads
Clean the tape heads after every 10 hours of use. Make sure to clean the tape heads before you start an important recording or after playing an old tape. Use a separately sold
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that have contact with the tape every 20 to 30 hours of use with a separately sold demagnetizing cassette. For details, refer to the instructions of the demagnetizing cassette.
In case color irregularity is observed on nearby a TV screen
With the magnetically shielded type of speaker system, the speakers can be installed near a TV set. However, color irregularity may still be observed on the TV screen depending on the type of your TV set.
If color irregularity is observed…
Turn off the TV set once, then turn it on after 15 to 30 minutes.
If color irregularity is observed again…
Place the speakers farther away from the TV set.
Troubleshooting
If you run into any problem using this unit, use the following check list.
First, check that the power cord is connected firmly and the speakers are connected correctly and firmly.
Should any problem persist, consult your nearest Sony dealer. When bringing the system in for repairs, be sure to bring in the entire system. This product is a system product, and the entire system is necessary to determine the location requiring to repair.
General
The display starts flashing as soon as you plug in the power cord even though you haven’t turned on the power.
•The demonstration mode started. Press ?/1 (see step 10 on page 12).
The clock setting/timer is canceled.
•The power cord is disconnected or a power failure occurs. Redo “Setting the time” (page 17). If you have set the timer, redo “Waking up to music” (page 56) and/or
continued
Information Additional
59