Additional Information
Precautions
On operating voltage
Before operating the unit, check that the operating voltage of your unit is identical with the voltage of your local power supply.
On safety
•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.
•Unplug the unit from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Never pull the cord itself.
•Should any solid object or liquid fall into the component, unplug the unit and have the component checked by qualified personnel before operating it any further.
•The AC power cord must be changed only at a qualified service shop.
On placement
•Do not place the unit in an inclined position.
•Do not place the unit in locations where it is:
—extremely hot or cold.
—dusty or dirty.
—very humid.
—vibrating.
—subject to direct sunlight.
•Use caution when placing the unit or speakers on surfaces that have been specially treated (with wax, oil, polish, etc.) as staining or discoloration of the surface may result.
On heat buildup
•Although the unit heats up during operation, this is not a malfunction.
•Place the unit in a location with adequate ventilation to prevent heat
If you continuously use this unit at a large volume, the cabinet temperature of the top, side and bottom rises considerably. To avoid burning yourself, do not touch the cabinet.
To prevent a malfunction, do not cover the ventilation hole for the cooling fan.
On operation
•If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player.
Should this occur, the unit will not operate properly. Remove the CD and leave the unit turned on for about an hour until the moisture evaporates.
•When you move the unit, take out any discs.
If you have any questions or problems concerning the unit, please consult your nearest Sony dealer.
58
Notes on discs
•Before playing, clean the disc with a cleaning cloth. Wipe the disc from the center out.
•Do not use solvents such as benzene, thinner, commercially available cleaners or
•Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight.
•Do not use discs encircled with a protection ring. This may cause a malfunction to the system.
•When using discs that have glue or similar tacky substance on the label side of the disc or that used a special ink when the label was printed, there is a chance that the disc or label may become attached to parts inside this unit. When this occurs, it may not be possible to remove the disc, and may also cause this unit to malfunction. Be sure to check that the label side of the disc is not sticky before using. The following types of disc should not be used:
—Rental or used discs with attached seals where the glue extends beyond the seal. The perimeter of the seal on the disc is tacky.
—Discs that have labels printed using a special ink that feels tacky when touched.
•Discs with
Music discs encoded with copyright protection technologies
This product is designed to playback discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product.
Note on
Discs recorded on
Cleaning the cabinet
Use a soft cloth slightly moistened with mild detergent solution.