Sony MZ-B100 Messages, 50-GB, Error message, Meaning/Remedy

Messages

If the following messages flash in the display window, check the chart below.

Error message	Meaning/Remedy
BLANKDISC	• An MD with no recording on it is inserted.
	,Insert a recorded MD.
BUSY	• You tried to operate the recorder while it was accessing the
	recorded data.
	,Wait until the message goes out (in rare cases, it may take 2–3
	minutes).
Data Save	• The MD player is recording information (sounds) from the
	memory to the disk.
	,Wait until this process is completed. Do not expose the player
	to any physical shock, nor disrupt power supply.
DISC ERR	• The disc is damaged or does not contain proper recording or
	editing data.
	,Reinsert the disc. If this fails, rerecord.
DISC FULL	• There is no more space to record on the disc (less than 12 seconds
	available).
	,Replace the disc.
EDITING	• You pressed a key on the recorder while editing on the remote
	control.
Hi DC in	• Voltage of the power supply is too high (The recommended AC
	power adaptor or the recommended car battery cord is not used).
	,Use the recommended AC power adaptor (not supplied) or the
	car battery cord (not supplied).
HOLD	• The recorder is locked.
	,Slide HOLD against the arrow to unlock the recorder
	(page 41).
LOW BATT	• Batteries are weak.
	,Replace the dry batteries (pages 9, 42).
MEM OVER	• You tried to record with the recorder placed where it receives
	continuous vibration.
	, Put the recorder on a stable place, and start recording again.
MENU	• You pressed a key on the remote control while selecting a menu on
	the recorder.
NAME FULL	• You tried to enter more than 200 letters to label a single track or
	disc.
	• You tried to enter a total of more than 1700 letters for track or disc
	names during playback or stop.
	,Enter a shorter name for the track, group, or disc (page 34), or
	delete “LP:” from the track name recorded in MDLP mode.

50-GB