Sony MZ-N505 Messages, 64-GB, Meaning/Remedy

Messages

If the following messages flash in the display window, check the messages below.

Error message	Meaning/Remedy
BLANK	• An MD with no recording on it is inserted.
BUSY	• You tried to operate the recorder while it was accessing the recorded
	data.
	,Wait until the message goes out (in rare cases, it may take a few
	minutes).
Saving	• The MD player is recording information (sounds) from the memory
	to the disc.
	,Wait until this process is completed. Do not expose the player to
	any physical shock, nor disrupt power supply.
ERROR	• Recording was not correctly done.
	,Place the recorder at a place with no vibrations and record again.
	• The disc is soiled with an oil film or finger prints, is scratched, or is
	not a standard disc.
	,Try recording again with another disc.
	• The recorder cannot read the disc information correctly.
	,Reinsert the disc.
	• The recorder cannot read the disc information correctly.
	,Insert another disc.
	,If it is no problem to erase the entire disc, do so (page 46).
FULL	• The remaining recording time on the disc is 12 seconds (stereo), 24
	seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
	,Replace the disc.
HiDCin	• Voltage of the power supply is too high (The supplied AC power
	adaptor or the recommended car battery cord is not used).
	,Use the supplied AC power adaptor or the recommended car
	battery cord.
HOLD	• The recorder is locked.
	,Slide HOLD against the arrow to unlock the recorder (page 14,
	49).
LoBATT	• Battery is weak.
	,Charge the rechargeable battery or replace the dry battery
	(page 13).
MEMORY	• You tried to record with the recorder placed where it receives
	continuous vibration.
	, Put the recorder on a stable place, and start recording again.

64-GB