Sony MZ-R35 32-EN, Error message, Meaning/Remedy

Messages

If the following error messages flash in the display window, check the chart below.

Error message	Meaning/Remedy
BLANK DISC	•An MD with no recording on it is inserted.
	b Insert a recorded MD.
DISC ERR	•The recorder cannot read the disc (it's scratched or dirty).
	b Reinsert or replace the disc.
DISC FULL	•There is no more space to record on the disc (less than 12
	seconds available).
	b Replace the disc.
BUSY	•You tried to operate the recorder while it was accessing the
	recorded data.
	b Wait until the message goes out (in rare cases, it may take
	2–3 minutes).
NAME FULL	•You tried to enter more than 200 characters for a track or disc
	name or the total characters entered in an MD is more than
	1700.
	b Enter the characters within the limit.
Hi DC in	•Voltage of the power supply is too high (The supplied AC
	power adaptor or the recommended car battery cord is not
	used).
	b Use the supplied AC power adaptor or the recommended
	car battery cord.
HOLD	•The recorder is locked.
	b Slide HOLD against the arrow to unlock the recorder
	(page 19).
LOW BATT	•Batteries are weak.
	b Charge the rechargeable battery or replace the dry
	batteries (pages 25, 26).
MEM OVER	•You tried to record when there is no indication in the display,
	with the recorder placed where it receives continuous
	vibration.
	b Put the recorder on a stable place, and start recording
	again.
NO COPY	•You tried to make a copy from a disc that is protected by the
	Serial Copy Management System. You cannot make copies
	from a digitally connected source which was itself recorded
	using digital connection.
	b Use analog connection instead (page 6).
NO DISC	•You tried to play or record with no disc in the recorder.
	b Insert an MD.

32-EN