
The recorder automatically divides a recording (a title) into chapters by inserting chapter marks at 5 or
zHints
•You can create chapters manually when playing a DVD+RW,
•When recording in ULP mode, chapter marks are inserted at
+RW
You can use the Title List to make a new recording over a title previously recorded on the disc. For details about the Title List, see page 30.
1
2 Press PROG +/– or INPUT to select a programme position or input source.
3
4 Press </M/m/, to select the title you want to overwrite.
5 Press z REC.
Recording starts.
To stop recording
Press x REC STOP. Note that it may take a few seconds for recording to stop.
zHint
If you erase a title from a DVD+RW, it appears as [Erase] in the Title List. This will not increase the remaining time on the disc. However, the remaining time will be increased when erasing the last title. You can select [Erase] from the Title List and make a new recording on top of it (page 56).
bNotes
•A protected title cannot be overwritten (page 57).
•If the selected title is shorter than the new recording, or less than ten seconds, the recorder automatically overwrites the next title in the Title List. If you do not want a title to be overwritten, protect the title (page 57).
Recording From Connected Equipment
+RW |
You can record from a connected VCR or similar device. To connect a VCR or similar device, see “Connecting a VCR or Similar Device” (page 22). Use the DV IN jack on the front panel if the equipment has a DV output jack (i.LINK jack).
1 | 2 | 3 | Recording |
| |||
4 | 5 | 6 |
|
7 | 8 | 9 | INPUT |
| 0 |
|
|
z REC |
|
| REC MODE |
x REC STOP
1 Insert a recordable disc.
2 Press INPUT to select an input source according to the connection you made.
The front panel display changes as follows:
Programme |
|
|
position | L1 | L2 |
dV L3
3 Press REC MODE repeatedly to select the recording mode.
The recording mode changes as follows:
HQ SP
LP
EP
ULP
4 Insert the source tape into the connected equipment and set to playback pause.
,continued 43