Setting the Code for Preset Audio and Visual Components (continued)
Checking if the code number works1Press the corresponding Component Select button for the component you have set up.
TV
The Commander turns on and the
TV
POWER
TV/VIDEO DISPLAY
1 2 3
SLEEP
4 5 6
7 | 8 | 9 | MENU |
EXECUTE
0RECALL ENTER
2Power on the component with its power switch.
3Aim the Commander at the component and press the POWER key in the
When the remote control signal is sent,
is displayed on the display.
POWER
The component should power off.
4If you have succeeded, check that the Commander is operating the other functions of your component, such as channel and volume control.
See page 11 for details.
If the Commander does not seem to
be working...
Try repeating these setup procedures using the other codes listed for your components (see page 8).
Notes on keys which have “learned” a remote control signal already
If another signal has alreday been programmed on that key or button by the learning function (page 13), that “learned” signal will work even after you set the component code number. To use it as a preset component key or button, first erase its learned signal.
Note on the
When you set a component code number, only the keys that have been preset with the signals for the desired component will be displayed. Preset signal of each key varies according to the brand.
By using the learning function, you can program remote control signals to both the displayed keys and keys that are not displayed (see page 13).
10