Assigning Other Components to the Component Select Buttons (continued)

3•If the newly assigned component is a Sony component, press COMMANDER OFF to finish this procedure.

•If you need to set the component code, follow the steps on pages 8 and 9.

•If you need to program some signals by the “learning” function, follow the Steps 1 and 3 to 6 on pages 13 and 14.

Notes

•If you hear beeps and “NG” flashes on the display when you press the Component Select button at Step 1, you can not assign another component because some of the keys or buttons are already programmed with the learning function (see page 25).

Try the above procedure again after clearing the learned signals for that component.

•You cannot press OPTION in Step 2 even if you have assigned a component on the OPTION button.

To assign an LD player (VD) or a Cable box (CBL) on another Component Select button

If the desired component (“VD” or “CBL”) is not displayed, before Step 3, repeat Step 2 again so that desired component (“VD”or “CBL”) flashes on the display.

To use the Commander after assigning other components

Press the reassigned Component Select button. The keys of the new component are displayed and you can use the desired component. Note however that only the original component name is displayed.

(In this example, the display would be like the one below.)

Original component name

VCR 3

POWER

1

2

3

D.SKIP

 

 

4

5

6

 

 

 

7

8

9

 

 

PGM

 

 

 

 

0

 

 

 

CONTINUE

+10

ENTER

CLEAR

SHUFFLE

REPEAT

 

 

 

keys for operating a CD player

To reset a Component Select button to its original setting

1While pressing COMMANDER OFF, press the Component Select button which you want to reset.

2While pressing the RESET key, press that Component Select button again. The setting for that Component Select button returns to the factory setting.

Note

If you have programed some signals on any of the keys or buttons with the learning function (see page 14) after you reassigned your component, the two steps above only clears the “learned” signals. In this case, perform Step 2 again to reset to the original Component Select button.

28