Adding an Extra Function to the Component Select Buttons (continued)

4Press and hold down the button on the component’s remote control (amplifier in this example) until you hear a beep.

INPUT SELECT

CD

5Press COMMANDER OFF.

COMMANDER

OFF

To clear the learned function of the Component Select button

1While pressing COMMANDER OFF, press VOLUME+ and CHANNEL+.

2While pressing the RESET key, press the Component Select button which you want to clear.

Note

•Even if that Component Select button has been programmed with the Power-on command (page 24), you can program any signal on it by the procedure above. However, the new signal overwrites the Power-on command, and even after you clear this new signal, the Power-on command will not resume.

Turning Off the Power of All Components by a Single Button Operation

—System Power-Off Function (for Sony Components only)

When the System Power-Off function is active, you can turn off all Sony components just by pressing the COMMANDER OFF button for three seconds.

To set the System Power-Off function

1While pressing COMMANDER OFF, press CHANNEL - and VOLUME +.

COMMANDER

CHANNEL

+

VOLUME

OFF

+

–

+

 

 

 

 

When the System Power-Off function is set, “POWER OFF” appears on the display. (The display goes off when you release the buttons.)

POWER

OFF

To cancel the System Power-Off function

Repeat the procedure above. The following display appears when the System Power-Off function is disabled.

POWER

26