Using
3Press the key or button on the Commander you want to “teach”.
“LEARN” flashes and the only pressed key remains on the dislplay.
LEARN VCR1
To teach on the CHANNEL
Press the corresponding button. “LEARN” flashes, “C+,
4Press and hold down the button on the other remote control until you hear a beep.
“LEARN” stops flashing and stays lit. When the comand has been learned successfuly, the learned keys stay lit and the other learnable keys flash.
If you hear beeps and “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4 again.
Certain signals may require the learning procedure more than once to complete learning. In this case, try Step 4 again if “NG” appears after Step 4.
5Repeat Steps 3 and 4 to teach functions to other kyes or buttons.
To learn another component’s remote control signal
After positioning the two remote commanders as in Step 1 on page 13, press the corresponding Component Select button, and then follow Steps 3 and 4 on the left to perform learning.
6Press COMMANDER OFF.
COMMANDER
OFF
Notes
•If you do not perform learning steps within two minutes, learning mode ends.
•If you do not perform Step 4 within 10 seconds after Step 3, the display turns back to the display in Step 2. (All the learnable keys flash.) In this case, perform Step 3 again while the display is flashing,
•If “NG” appears while learning, the memory is full. To free memory, clear learned functions from keys that you do not use often (page 16). Then continue the learning steps.
•If you touch a key by mistake, while pressing “RESET” key, press the mistaken key. Then repeat from Step 2 to continue learning.
If the Commander does not seem to be working
If the learned key or button does not operate properly, teach once again. (For example, if the volume becomes very loud after pressing the VOLUME+ button only once, noise may have interfered during the learning procedure.)
14