3Press the Component Select button* for the desired component.

TV

The selected component remains displayed, and the 0 – 9, ENTER and DISPLAY keys flash.

TV

1

2

3

DISPLAY

 

 

 

VIDEO2

4 5 6

7 8 9

0

ENTER

*When you set the component code of the DVD or DBS/CBL button,press repeatedly until the desired component is displayed.

4Press the double digit component code number followed by the ENTER key on the touch-key display.

1 2 3

4 5 6

7 8 9

0

ENTER

A beep sounds, and the code numbers and “ENTER” appear twice.

1 m 1 m ENTER

5If you want to set a code for another component, repeat Steps 3 and 4.

6Press COMMANDER OFF.

COMMANDER

OFF

Notes

•If you press a component code number that is not on the table in the supplied “Component Code Numbers”, the Commander beeps and “NG” flashes after you press the ENTER key. If this happens,check the component code number, and try setting again.

•If you don’t input anything into the Commander for over two minutes between each step, the setup procedure will be canceled. To set the code, you must again press MUTING while pressing

COMMANDER OFF.

To check which code number is set

Press the DISPLAY key. The code number and “ENTER” appear twice.

To set a component code on the OPTION button

Assign a component to the OPTION button first (see page 17), and then follow the procedure on page 8 to 9.

Continued 9