5If you want to set a code for another component, repeat Steps 3 and 4.

6Press COMMANDER OFF.

COMMANDER

OFF

Notes

• If you press a component code number that is

not on the table in the supplied “Component

Code Numbers”, the Commander beeps and

Checking if the code number works

1Press the corresponding Component Select button for the component you have set up.

TV

The Commander turns on and the touch-keys appear on the display.

TV

u

 

RED INPUT

 

“NG” flashes after you press the ENTER key.

If this happens,check the component code

number, and try setting again.

1 2 3

4 5 6

GREEN TV

• If you don’t input anything into the

Commander for over two minutes between

YELLOW TELETEXT

7 8 9

-/--

BLUE

each step, the setup procedure will be

canceled. To set the code, you must again

press ¤while pressing COMMANDER OFF.

To check which code number is set

Press the DISPLAY key. The code number and “ENTER” appear twice.

1- 0

2Power on the component with its power switch.

3Aim the Commander at the component and press the ukey in the touch-key display.

When the remote control signal is sent,is displayed on the display.

u

The component should power off.

Continued 9EN