Using Non-Preset Remote Control Operations — Learning Function (continued)

5Repeat Steps 3 and 4 to teach functions to other keys or buttons.

To learn another component’s remote control signal

After positioning the two remote commanders as in Step 1 on page 13, press the corresponding Component Select button, and then follow Steps 3 and 4 on page 13 to perform learning.

6Press COMMANDER OFF.

COMMANDER

OFF

Notes

•If you do not perform learning steps within two minutes, learning mode ends.

•If you do not perform Step 4 within 10 seconds after Step 3, the display turns back to the display in Step 2. (All the learnable keys flash.) In this case, perform Step 3 again while the display is flashing,

•If “NG” appears while learning, the memory is full. To free memory, clear learned functions from keys that you do not use often (page 15). Then continue the learning steps.

•If you touch a key by mistake, while pressing “RESET” key, press the mistaken key. Then repeat from Step 2 to continue learning.

If the Commander does not seem to be working

If the learned key or button does not operate properly, teach once again. (For example, if the volume becomes very loud after pressing the

Á+ button only once, noise may have interfered during the learning procedure.)

For accurate learning

•Do not move the remote units during the learning procedure.

•Be sure to keep holding down the button of your component’s remote control until you hear the confirmation beep.

•Use fresh battery in both remote units. •Avoid learning in places under direct sunlight or a strong fluorescent light. •The remote control detector area may

differ depending on each remote unit. If learning does not work, try changing the positions of the two remote control units.

IMPORTANT

Be sure to place the Commander out of the reach of small children or pets. Components such as air-conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused.

When you teach the signals for a double cassette deck

Press DECK B/A to select deck A or B.

When you teach the REC (record) signal for VCR1, 2, or 3

In Step 3, while pressing the REC key, press the (key to display both keys, then follow Steps 4 to 6. The Commander can not learn the remote control signal with just the REC key lit up.

When you teach signals on the

Áor ¤ buttons

For components other than TV or AMP, be sure to read the notes on pages 17 and 18.

14EN