Sony RM-AV2000T Turning Off the Power of All Components by a Single Button Operation, 25EN

4Press and hold down the button on your component’s remote control (amplifier in this example) until you hear a beep.

INPUT SELECT

CD

5Press COMMANDER OFF.

COMMANDER

OFF

Turning Off the Power of All Components by a Single Button Operation

—System Power-Off Function (for Sony Components only)

When the System Power-Off function is active, you can turn off all Sony components just by pressing the COMMANDER OFF button for three seconds.

To clear the learned function of the Component Select button

1While pressing COMMANDER OFF, press Á+ and PROGRAM +.

2While pressing the RESET key, press the Component Select button which you want to clear.

Note

Even if that Component Select button has been programmed with the Power-on command (page 23), you can program any signal on it by the procedure above. However, the new signal overwrites the Power-on command, and even after you clear this new signal, the Power-on command will not resume.

To set the System Power-Off function

1While pressing COMMANDER OFF, press PROGRAM – and Á+.

COMMANDER		PROGRAM	+	Á
OFF	+–			+

=

When the System Power-Off function is set, “uOFF” appears on the display. (The display goes off when you release the buttons.)

u

OFF

To cancel the System Power-Off function

Repeat the procedure above. The following display appears when the System Power-Off function is disabled.

u

25EN