2Press the desired key in the touch key display.
When the remote control signal is sent,
is displayed on the display.
You may also use the Á+/– buttons, the ¤button and the PROGRAM +/– buttons if necessary.
3When you are done using the Commander, press COMMANDER OFF to power off the Commander.
COMMANDER
OFF
Note
The remote control signals may be different for some components or functions. In this case, program the remote control signals with the learning function (see page 12). Note, however, that components and functions that do not support the remote control of infrared signals will not work with this Commander.
To control the volume
Press the Á+/– buttons to control the volume, and the ¤button to mute. When you select a visual component, the TV’s volume will be controlled, and when you select an audio component, the amplifier’s volume will be controlled. You can change this setting also
(page 17).
When you operate a Sony VCR
Select the VCR1, 2, or 3 button to match the VTR1, 2 or 3 switch on your VCR. If your VCR does not have a VTR1, 2, or 3 switch, select VCR1, 2, or 3 according to the type of VCR as follows.
BetamaxVCR1
8mmVCR2
VHSVCR3
When you operate a VCR REC (record) key
In order to avoid recording by mistake, the REC key does not work by itself. To record, you must press the (key while pressing the REC key.
When you operate a double cassette deck
You need to select deck A or B before operating. To select the deck, press DECK B/A to switch the display between “DECK A” and “DECK B”.
If the remote control for your cassette deck has only one set of operating buttons and has an A/B button for selecting a deck, press the D.SKIP key in the
Continued 11EN