When you assign a cassette deck (DECK B/A) to another Component Select button
You cannot assign both decks A and B at a time to one button.
If the desired deck (A or B) is not displayed, finish the procedure by pressing COMMANDER OFF and press DECK B/A to select the desired deck, and then start over from Step 1.
3•If the newly assigned component is a Sony component, press COMMANDER OFF to finish this procedure.
•If you need to set the component code, follow the steps on pages 7 – 10.
•If you need to program some signals by the “learning” function, follow the Steps 1 and 3 to 6 on pages 13 and 14.
Note
If you hear beeps and “NG” flashes on the display when you press the Component Select button at Step 1, you can not assign another component because some of the keys or buttons are already programmed with the learning function (see page 12).
Try the above procedure again after clearing the learned signals for that component.
To assign an LD player (VD) or Cable box (CBL) to another Component Select button
If the desired component (“VD” or “CBL”) is not displayed, before Step 3, repeat Step 2 again so that the desired component (“VD” or “CBL”) flashes on the display.
To use the Commander after assigning other components
Press the reassigned Component Select button. The keys of the new component are displayed and you can use the desired component. Note however that only the original component name is displayed.
(In this example, the display would be like the one below.)
Original component name
|
|
| VCR | 3 | u | |
|
|
|
|
| ||
1 | 2 | 3 | D.SKIP |
|
| |
4 | 5 | 6 |
|
|
| |
7 | 8 | 9 |
|
| PGM | |
|
|
| ||||
0 |
|
|
| CONTINUE | ||
|
|
|
| |||
1- | 2- | CLEAR | SHUFFLE | REPEAT | ||
|
keys for operating a CD player
To reset a Component Select button to its original setting
1While pressing COMMANDER OFF, press the Component Select button which you want to reset.
2While pressing the RESET key, press that Component Select button again. The setting for that Component Select button returns to the factory setting.
Note
If you have programed some signals on any of the keys or buttons with the learning function (see page 12) after you reassigned your component, the two steps above only clears the “learned” signals. In this case, perform Step 2 again to reset to the original Component Select button.