Example: To program the (

(Play) signal of your component to the VCR1 ( (Play) key of the

Commander

1Place the RM-AV2000T head to head with your component’s remote control.

Remote control for your component

about 5 – 10 cm

 

(2 – 4 inches)

RM-AV2000T

away

2While pressing COMMANDER OFF, press the Component Select button for the component whose signals are to be learned.

COMMANDER

OFF + VCR1

All the learnable keys flash.

RESET

 

LEARN NG

VCR1

u

 

 

 

 

P + P – V + V –

 

 

 

MU

 

 

1

2

3

INPUT

 

 

 

4

5

6

 

REC

7

8

9

ANT SW

 

-/--

1- 0 2-

Display for PROGRAM, Á and ¤ buttons

The “P+ P– V+ V– MU” display indicates if PROGRAM +/–, Á+/– and ¤buttons are learnable or not.

Note on the flashing display

The keys or buttons that are already preset for that component flash twice while those that are not preset flash once.

3Press the key or button on the Commander you want to “teach”.

“LEARN” flashes and the only pressed key remains on the display.

LEARN NG VCR1

To teach on the PROGRAM +/–,

Á+/– or ¤ buttons

Press the corresponding button. “LEARN” flashes, “P+”, “P–”, “V+”, “V–”, or “MU” remains on the display.

4Press and hold down the button of your component’s remote control until you hear a beep.

“LEARN” stops flashing and stays lit. When the signal has been learned successfully, the learned keys stay lit and the other learnable keys flash.

If you hear beeps and “NG” flashes on the display

Learning did not succeed. Try Steps 3 and 4 again.

Certain signals may require the learning procedure more than once to complete learning. In this case, try Step 4 again if “NG” appears after Step 4.

Continued 13EN