Additional Information

Troubleshooting

Should you encounter a problem with your speaker system, check the following list and follow the indicated measures. If the problem persists, consult your nearest Sony dealer.

There is no sound from the speaker system.

/Make sure all the connections are correct.

/Adjust the volume pressing the LEVEL +/– (or MASTER VOL +/– on the remote).

/Make sure the program source selector on the subwoofer is set to the proper source.

There is no sound from the subwoofer.

/When you connect the subwoofer to the DVP-F11, make sure the subwoofer setting is “YES.”

/When you connect the subwoofer to a component other than the DVP-F11, connect it to the AUX IN jacks of the subwoofer.

There is hum or noise in the speaker output.

/Make sure all the connections are correct.

The sound has suddenly stopped.

/Make sure all the connections are correct. Contact between bare speaker wires at the speaker terminals may cause a short-circuit.

Specifications

SS-MS11 (front speakers)

Speaker system

Full range, magnetically shielded

Speaker units

5 ⋅ 9 cm, cone type

Enclosure type

Bass reflex

Rated impedance

6 ohms

Power handling capacity

Maximum input power:100 watts

Sensitivity level

86 dB (1 W, 1 m)

Frequency range

90 Hz - 20,000 Hz

Dimensions (w/h/d)

Approx. 68 ⋅ 151 ⋅ 135 mm, including

 

front grille

Mass

Approx. 790 g each

SA-WMS11 (subwoofer)

System

Speaker system

Active subwoofer, magnetically shielded

Speaker unit

Woofer: 13 cm, cone type, dual voice coil

Enclosure type

SAW type

Reproduction frequency range

 

40 Hz - 200 Hz

Power output

Front

20 W ⋅ 2

Subwoofer

20 W + 20 W

Inputs

DVD IN (input pin jacks)

AUX IN (input pin jacks)

Outputs

SPEAKER OUT (output terminals)

General

Power requirements

220 - 230 V AC, 50/60 Hz

Power consumptions

42 W

Dimensions (w/h/d)

Approx. 145 ⋅ 237 ⋅ 373 mm

Mass

Approx. 6.3 kg

Supplied accessories

See page 3.

Design and specifications are subject to change without notice.

9GB