No need for specific drivers

The monitor complies with the “DDC” Plug & Play standard and automatically detects all the monitor’s information. No specific driver needs to be installed to the computer.

The first time you turn on your computer after connecting the monitor, the setup Wizard may appear on the screen. In this case, follow the on-screen instructions. The Plug & Play monitor is automatically selected so that you can use this monitor.

The vertical frequency turns to 60 Hz.

Since flickers are unobtrusive on the monitor, you can use it as it is. You do not need to set the vertical frequency to any particular high value.

Adjusting the tilt

This display can be adjusted within the angles shown below.

Approx. 20°

Grasp the lower sides of the LCD panel, then adjust screen tilt.

Selecting the input signal

(INPUT button)

Press the INPUT button.

The input signal changes each time you press this button.

On-screen message

Input signal configuration

(Appears about 5 seconds on

 

the upper left corner.)

 

 

 

INPUT1 : DVI-D

DVI-D input connector

 

(digital RGB) for INPUT1

 

 

INPUT2 : HD15

HD15 input connector

 

(analog RGB) for INPUT2

 

 

To use the display comfortably

This display is designed so that you can set it up at a comfortable viewing angle. Adjust the viewing angle of your display according to the height of the desk and chair, and so that light is not reflected from the screen to your eyes.

Note

When adjusting the screen tilt, make sure not to knock or drop the display off the desk.

9 (GB)