dd-mm-yyyy hh:mm:ss (day-month-year hour:minute:second).

Adjust

Select to set the day and time.

Keep current setting: Select when you do not need to set the date and time.

Synchronize with PC: Select when synchronizing the camera’s date and time with those of the computer.

Manual setting: Select when you want to set the camera’s date and time manually.

Select the lower 2-digits of year, month, date, hour, minutes and seconds from each drop-down list.

Synchronize with NTP: Select when synchronizing the camera’s date and time with those of the time sever called NTP server (Network Time Protocol). Set the NTP saver name and the Interval time.

NTP server name

Type the host name or IP address of the NTP server, up to 64 characters.

Interval time

Select the interval at which you want to adjust the camera’s time referring to the NTP server’ time, between 1 and 24 hours. The set interval is a guide, and does not indicate the exact time.

Note

The setting time may not accord with the exact time according to the network environment.

Time zone

Set the time difference from Greenwich Mean Time in the area where the camera is installed.

Select the time zone where the camera is installed from the list box.

Automatically adjust clock for daylight saving time changes

When you select it, the clock is automatically adjusted according to the daylight saving time of the selected time zone.

Note

If the time zone selected on the Time zone menu is different from that set on the computer, the time is adjusted using the time zone difference and set on the camera.

OK/Cancel

See “Buttons common to every setting menu” on page 31.

Initialize TabReboot

Reboots the camera.

Click Reboot, and “The SNC-P5 will be rebooted. Are you sure?” appears. Click OK to reboot the camera. It takes about two minutes to start again.

Factory default

Resets the camera to the factory settings.

Click Factory default, and “Set up data will be initialized. Are you sure?” appears. When you click OK, the network indicator on the camera starts to blink. After adjustments of the default settings have finished, the camera reboots automatically. Do not turn off the camera until the camera reboots.

Tip

You can also reset the camera to the factory setting by turning on the power while pressing the reset switch of the camera. For details, refer to the supplied Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.

Click Save, and follow the instructions on the browser to specify the folder and save the setting data of the camera. The file name preset at the factory is “snc- p5.cfg.”

Restore setting

Loads the stored setting data of the camera.

Click Browse and select the file in which the setting data is stored. Then, click OK, and the camera is adjusted according to the loaded data and restarted.

Camera the Administrating

Configuring the System — System setting menu

35