Others

Information boxes on the selected file are displayed on the left side of the window as follows:

Each click on the (information) icon switches between “display” and “Not to display” of the file information.

Model name: Model name of the camera with which the file is recorded.

IP address: IP address of the camera with which the file is recorded.

Serial number: Serial number of the camera with which the file is recorded.

Record event: Type of event used for the recording: Sensor input, Periodical, Motion detection or Manual.

Date&time: Recording date and time

Movie: Video CODEC

Audio: Audio CODEC

Playing a video/audio file

Click (start) to start playing from the beginning of the selected file.

To freeze the movie temporarily, click (pause).

Click again to restart playing.

To stop playing, click (stop).

To restart playing from the beginning, click (start) again.

Play stops when the file is played to the end.

To play from a specified point

Move the slider bar below the image display, and playing starts according to the slider bar position.

Adjusting the sound

Adjust the playing sound volume by moving the

slider bar. Move it to the left end for the minimum volume, and to the right end for the maximum volume.

Click the speaker icon to enable/disable the sound muting.

When the sound muting is on, no sound is heard even if you move the slider bar to the right.

Saving an image

Click (capture) icon during playing or pause and the captured image is displayed on a pop-up dialog. To save the image, click Save on the dialog. You can specify the destination to which the image is to be stored and select the JPEG (or Bitmap) format.

How to use SNC panorama creator

After starting the installed SNC panorama creator, the following window is displayed. It is composed of Main tab to create a panorama image and Setting tab to connect with the camera.

Preparing to connect with the camera

To create a panorama image, you need to connect it to the camera.

Input the following items of Setting tab for connection.

Administrator name: Input the user name of the camera administrator.

Administrator password: Input the password of the camera administrator.

Tip

“admin” has been set for each item in the factory. Camera address: Input IP address or the host name of

the camera.

Camera port No.: Set the camera HTTP port number. The camera HTTP port number has been set to “80” in the factory.

To connect with the camera through a proxy server, check the check box Use proxy and input the following items.

Proxy server address: Input IP address or the host name of the proxy server.

Proxy server port No.: Input the port number of the proxy server.

70 How to use SNC panorama creator