Note
Do not turn off the camera until the camera is rebooted after uploading the homepage file.
The following page will appear after a while.
After displaying this page, the camera will be adjusted and rebooted automatically in two minutes.
13 Click Finish to exit the program.
Assigning the IP Address to the Camera Using ARP Commands
This section explains how to assign an IP address to the camera using ARP (Address Resolution Protocol) commands without using the supplied setup program.
Note
Enter the ARP commands within 5 minutes of the power of the camera being turned on.
1 Open the DOS window on the computer.
2 Enter the IP address and the MAC address of the camera to assign a new IP address, using the following ARP commands.
arp
Example:
arp
3 When the following line is displayed on the DOS window, hold down Ctrl and press C.
Reply from 192.168.0.100:bytes=32 time...
You will normally receive a reply after about 5 repetitions of “Request time out.”
Note
If you do not receive a reply, check the following:
–Did you enter the ARP commands within 5 minutes of the camera being turned on?
If not, turn off the camera and restart the operation.
–Is the NETWORK indicator on the camera flashing? If the indicator goes off, the network connection has a problem. Connect the network correctly.
–Did you enter the IP address previously used for another device?
Assign a new IP address to the camera.
–Do the computer excuted a ping command and the camera have the same network address?
If not, set the same network address on the computer and the camera.
Others
Assigning the IP Address to the Camera Using ARP Commands 73