“TUNER”, then press the key repeatedly to select “FM” or “AM”.
You can also use INPUT SELECTOR on the receiver.
2 Press D.TUNING on the remote.
3 Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz Select 1 b 0 b 2 b 5 Example 2: AM 1,350 kHz Select 1 b 3 b 5 b 0
(You do not have to enter the last “0” when the tuning scale is set to 10 kHz.)
If you have tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception.
If you cannot tune in a station and the entered numbers flash
Make sure you have entered the right frequency. If not, repeat step 3. If the entered numbers still flash, the frequency is not used in your area.
Move the easy scroll key to select
1
Direct tuning
You can enter the frequency of the station you want directly. Use the remote for this operation.
Listening to FM/AM radio

You can listen to FM and AM broadcasts through the built-in tuner. Before operation, make sure you have connected the FM and AM antennas to the receiver (see page 14).

Tip

The tuning scale is:

FM: 100 kHz

AM: 10 kHz*

* The AM tuning scale can be changed (see page 76).

Automatic tuning1 Rotate INPUT SELECTOR to select tuner (“FM” or “AM”).2 Press FM/AM to select “FM” or “AM”.3 Press TUNING + or TUNING –.

Press TUNING + to scan from low to high; press TUNING – to scan from high to low. The receiver stops scanning whenever a station is received.

In case of poor FM stereo reception

If the FM stereo reception is poor and “STEREO” flashes in the display, select monaural audio so that the sound will be less distorted.

1Rotate MAIN MENU to select “TUNER”.

2Rotate MENU to select “FM MODE”.

3Rotate –/+ to select “MONO”.

The FM reception switches to monaural.

Operation Amplifier
25US