Notes
•Some functions explained in this section may not work depending on the model.
•The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described.
Changing button assignments
You can change the factory settings of the input buttons to suit the components in your system. For example, if you connect a LD player to the VIDEO 2 jacks on the receiver, you can set the VIDEO 2 button on this remote to control the LD player.
Note, however, that the settings of the TUNER button cannot be changed.
1 Press RM SET UP for more than 2 seconds.The indicator lights up.
2 Press the input button you want to change the assignment of.The indicator turns off once and turns on again when a valid button is pressed. Only the first input button that is pressed will be registered.
Example: Press VIDEO 2.
3 Refering to the table below, press the input button for the category you want.
The indicator turns off when a valid button is pressed.
Example: Press DVD twice.
4 Press SOURCE.The new assignment is registered.
The indicator slowly lights up twice, then goes off.
To cancelPress RM SET UP during any step.
Tips
•If the operation is unsuccessful, the indicator flashes four times and the remote automatically exits the button assignment mode. In this case, the new assignment is not registered and the previous setting remains.
•Use a suitable tool to press RM SET UP button.
continued