Changing the command mode of the receiver
This function is useful when you use 2 Sony receivers in the same room.
1 Turn off the receiver.2 Hold down INPUT MODE and press ?/1 to turn on the receiver.“COMMAND MODE [AVX]” appears in the display. Each time you repeat the procedure above, the display changes as follows:
COMMAND MODE [AV1] y
COMMAND MODE [AV2]
Tip
The initial setting is “COMMAND MODE [AV2]”.
Notes
•The initial setting for the command mode of the supplied remote is “AV2”.
•If the command mode of the receiver and the remote is different, you cannont use the remote to operate the receiver.
Using the Sleep Timer
You can set the receiver to turn off automatically at a specified time by using the remote.
Press ALT, then press SLEEP repeatedly while the power is on.Each time you select or press SLEEP, the display changes cyclically as follows:
2:00:00 t 1:30:00 t 1:00:00 t 0:30:00 t
OFF
While using Sleep Timer, “SLEEP” lights up in the display.
Tip
To check the remaining time before the receiver turns off, press ALT, then press SLEEP. The remaining time appears in the display.