Amplifier Operation
Selecting the component
1 Rotate INPUT SELECTOR to select the input.The selected input appears in the display.
To select the | Display |
VCR | VIDEO 1, VIDEO 2, |
| VIDEO 3 or |
| VIDEO 4 |
|
|
Camcorder or TV game | VIDEO 5 |
|
|
LD player | LD |
|
|
DVD player | DVD |
|
|
Satellite tuner | TV/SAT |
|
|
Tape deck | TAPE |
|
|
MD or DAT deck | MD/DAT |
|
|
CD or Super Audio CD | CD/SACD |
player |
|
|
|
FM or AM and | |
| frequency |
|
|
Turntable | PHONO |
|
|
i.LINK component* | i.LINK |
|
|
* See “Note when “i.LINK” is selected” below.
2 Turn on the component and start playback.3 Rotate MASTER VOLUME to adjust the volume.Note when “i.LINK” is selected
When “i.POWER” is set to “AUTO” (page 41), the power of the i.LINK circuits turns on after “i.LINK” is selected, and “i.LINK Connecting” appears in the display while the power of the i.LINK circuits is turning on. While this message appears, no sound is output because LINC is not established. (See page 57 for details on LINC.)
Make sure to control the player after “i.LINK Connecting” turns off.
The connected i.LINK component name appears except in the following cases.
“No LINC” : No i.LINK component is connected when “i.LINK” is selected.
“Disc”: The receiver could obtain only general information from the connected component. “Unknown”: The receiver could not obtain information from the connected component.
Press MUTING on the remote. To cancel, press |
| |
MUTING on the remote again or turn MASTER |
| |
VOLUME clockwise to raise the volume. Even |
| |
| ||
if you turn off the receiver, the muting function |
| |
Amplifier | ||
continues to mute the sound when you turn the | ||
| ||
receiver back on. |
| |
| Note on using headphones |
| |
When headphones are connected, you can select only | Operation | |
the following sound fields (page 33). | ||
| ||
– HEADPHONE (2CH) |
| |
– HEADPHONE (DIRECT) |
| |
– HEADPHONE (MULTI 1) |
| |
– HEADPHONE (MULTI 2) |
| |
– HEADPHONE THEATER |
|