Before performing the initial setup

Before performing the initial setup procedure, be sure to perform the following operations.

Connecting the AC power cord

Connect the AC power cord to a wall outlet.

b

To a wall outlet

AC power cord

Before you use your remote

Inserting batteries into the remote

Insert two R6 (size AA) batteries with the polarity (+ and –) properly oriented in the battery compartment.

Tip

Under normal conditions, the batteries should last for about 6 months. When the remote no longer operates the control center, replace both batteries with new ones.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with an old one.

•Do not expose the remote sensor of the control center to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•When not using the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

•Turn off the power to all components before making any connections.

•Be sure to make connections firmly to avoid humming and noise.

About the remote operation

•The instructions in this manual are described using the controls on the remote. You may also use the controls on the receiver if they are of the same or similar name as those on the remote.

•The initial settings are underlined.

Performing initial setup operations

Before using the receiver for the first time, perform the initialization procedure as follows. This procedure can also be used to return settings you have made to their factory defaults.

Press ?/1 while pressing 2CH. When “CONFIRM” appears, press 2CH again.

The following items are reset or cleared:

•All sound field parameters

•All parameters in the SET UP, LEVEL and TONE menus

•Sound fields memorized for each program source

•Preset stations

Further, the master volume is set to the minimum value.

Components up Hooking

11GB