Programming the remote

You can program the remote to control non- Sony components. Once the control signals have been memorized, you can use those components as part of your system.

Furthermore, you can also program the remote for Sony components that the remote is unable to control. Note that the remote can only control components that accept infrared wireless control signals.

1 Press AV ?/1 while holding down RM SET UP P.

RM SET UP P lights up once.

2 Press one of the input buttons to select the input you want to control.

For example, if you are going to control a DVD player, press DVD.

You can also select TV ?/1.

3 Press the number buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control.

See the tables starting from page 39 for information on the numeric code(s) corresponding to the component and the maker of the component. (The first digit and the last two digits of the numeric code correspond to the category and the maker’s code respectively.)

4 Press ENTER.

Once the numeric code has been verified, RM SET UP P slowly flashes twice and the remote automatically exits the programming mode.

5 Repeat steps 1 to 4 to control other components.

To cancel programming

Press RM SET UP P during any step. The remote automatically exits the programming mode.

To use the programmed input

Press the programmed input buttons.

If programming is unsuccessful, check the following:

•If RM SET UP P does not light up in step 1, the batteries are weak. Replace both batteries.

•If RM SET UP Pflashes 4 times in quick succession while entering the numeric code, an error has occurred. Start again from step 1.

•In step 1, the remote automatically exits the programming mode if 60 seconds has passed after pressing RM SET UP P. Start again from step 1.

Notes

•RM SET UP P lights up while a valid button is pressed.

•In step 2, if you press the input buttons several times, only the last selected input is valid.

•In step 2, if you press TV ?/1, only TV VOL +/–, TV CH +/–, TV/SAT, TV/VIDEO and WIDE buttons are reprogrammed.

•In step 3, if you press the input buttons, the new input is selected and the programming procedure returns to the beginning of step 3.

•For the numeric codes, only the first three numbers entered are valid.

To clear the memory of the remote

Press ?/1, AV ?/1 and MASTER VOL – at the same time. RM SET UP Pflashes 3 times, then goes off.

38GB