Press AUTO CAL.

Measurement starts in 5 seconds. A count down is displayed.

The measurement process will take approximately 30 seconds to complete. The table below shows the display when measurement starts.

Measurement for

Display

Speaker existence

TONE

 

 

Speaker gain, distance, frequency

T.S.P.

response

 

 

 

Subwoofer gain and distance

WOOFER

 

 

Tips

•Operations other than turning the receiver on or off are deactivated during the measurement.

•The measurements may not be performed correctly or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used.

To cancel Auto Calibration

The Auto Calibration function will be canceled when you do the following during the measurement process:

–Press ?/1 or POWER on the receiver.

–Press the input buttons or turn the INPUT SELECTOR on the receiver.

–Change the volume level.

–Press MUTING.

–Change the setting of the SPEAKERS (OFF/ A/B/A+B).

–Connect headphones.

–Press AUTO CAL again.

Confirming/saving the measurement results

1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display

Explanation

result

 

 

 

 

 

When the

SAVE EXIT

Proceed to step

measurement

 

2.

process

 

 

completes

 

 

properly

 

 

 

 

 

When the

E -

See “Message

measurement xxx:xx list after Auto

process fails

Calibration

 

measurement”

 

(page 35).

2 Press AMP and then press V/v repeatedly to select the item. Then, press .

Item

Explanation

EXIT

Exits the setting process

 

without saving the

 

measurement results.

 

 

LEVEL INFO.

Displays the measurement

 

result for speaker level.

 

 

DIST. INFO.

Displays the measurement

 

result for speaker distance.

 

 

PHASE INFO.

Displays the phase of each

 

speaker (in phase/out of

 

phase). See “When you

 

select “PHASE INFO.””

 

(page 34).

 

WARN CHECK Displays warning

 

concerning the

 

measurement results. See

 

“When you select “WARN

 

CHECK”” (page 36).

 

 

SAVE EXIT

Saves the measurement

 

results and exits the setting

 

process.

 

 

RETRY

Performs the Auto

 

Calibration again.

 

 

continued

Started Getting

33GB