3 Save the measurement result.
Select “SAVE EXIT” in step 2.
The measurement results are saved and you can select the calibration type in the AUTO CAL menu.
For details on calibration type, see page 36.
When measurement ends, “COMPLETE” appears on the display and the settings are registered as selected position number.
Note
You can select the position number to save the Auto Calibration result. Select a position number before you perform Auto Calibration. For details, see page 36.
If you do not select the position number, the Auto Calibration result will automatically save as POS. 1 (initial setting).
Tip
The size of a speaker (LARGE/SMALL) is determined by the low frequency characteristics.
The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the SPEAKER menu (page 48). Save the measurement results first, then try to change the settings if you want.
When you select “PHASE INFO.”You can check the phase of each speaker (in phase/out of phase).
Press V/v repeatedly to select a speaker, then press to return to step 2 in “Confirming/saving the measurement results”.
Display Explanation
xxx* - IN The speaker is in phase.
xxx* - OUT The speaker is out of phase. The “+” and
* xxx represent a speaker channel.
F | Front |
FL | Front left |
FR | Front right |
CNT | Center |
S | Surround |
SL | Surround left |
SR | Surround right |
SB | Surround back |
SBL | Surround back left |
SBR | Surround back right |
SW | Subwoofer |
Tip
Depending on the position of the subwoofer, the measurement results for polarity may vary. However, there will be no problems even if you continue to use the receiver with that value.
After you have finished
Disconnect the optimizer microphone from the receiver.
Note
If you have reposition your speaker, we recommend that you perform Auto Calibration again to enjoy the surround sound.
34GB