Video

There is no picture or an unclear picture appears on the TV screen or monitor.

•Select the appropriate input using the input buttons.

•Set your TV to the appropriate input mode.

•Move your audio components away from the TV.

•Depending on the DIGITAL MEDIA PORT adapter, video output may not be possible.

The image of the COMPONENT VIDEO OUT is corrupted.

•Video input signals other than 480p component are not received when signals are output from the VIDEO jack. Input 480i component video signals.

Recording cannot be carried out.

•Check that the components are connected correctly.

•Select the source component using the input buttons (page 38).

Tuner

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.

Outdoor FM antenna (aerial)

Receiver

FM AM

 

Ground (earth)

ANTENNA

wire (not

supplied)

 

To ground

Radio stations cannot be tuned in.

•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 65).

•Press DISPLAY repeatedly on the receiver so that the frequency appears on the display.

•Keep the satellite radio antenna (aerial) away from the speaker cords and the power cord to avoid picking up noise.

94GB