Hooking Up the Components

This chapter describes how to connect various audio and video components to the control amplifier. Be sure to read the sections for the components you have before you actually connect them to the control amplifier.

Unpacking

Check that you received the following items with the unit:

•Audio Cord (3)

•Remote commander RM-TP501E (remote) (1)

•LR6 (size-AA) alkaline batteries (4)

•Coin shaped lithium battery (CR-2032) (1)

Inserting batteries into the remote

Insert four size-AA (LR6) alkaline batteries and one coin shaped lithium battery with the + and – properly oriented in the battery compartment. When using the remote, point it at the remote sensor gon the control amplifier. For details, refer to the operating instructions supplied with your remote.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use new batteries with old ones.

•Do not mix battery types. This remote is designed for use with alkaline batteries only.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Before you get started

•Turn off the power to all components before making any connections.

•Do not connect the AC power cords until all of the connections are completed.

•Be sure to make connections firmly to avoid hum and noise.

•When connecting an audio/video cord, be sure to match the color-coded pins to the appropriate jacks on the components: yellow (video) to yellow; white (left, audio) to white; and red (right, audio) to red.

4GB