Sony DCR-TRV60, TRV70 (p. 148, 153), • USB STREAM in, condensation (p. 202), USB driver was complete, c Set it to ON (p. 180), cSet it to OFF (CHG) (p. 16)

Types of trouble and how to correct trouble

Symptom Cause and/or Corrective Actions

The melody or beep sounds for five seconds.

• Moisture condensation has occurred.

cRemove the cassette and leave your camcorder for at least one hour to acclimatize (p. 202).

•Some troubles have occurred in your camcorder.cRemove the cassette and insert it again, then operate your camcorder.

No function works though the power is on.

cDisconnect the AC Adaptor from a wall outlet or remove the battery pack, then reconnect it in about one minute. Turn the power on. If the functions still do not work, press the RESET button using a sharp-pointed object. (If you press the RESET button, all the settings (DCR-TRV70: except the network settings) including the date and time return to the default) (p. 15, 16, 211).

When you set the POWER switch to VCR or OFF (CHG), if you move your camcorder, you may hear a clattering sound from inside your camcorder.

•This is because some functions use a linear mechanism. This is not a malfunction.

While charging the battery pack, the CHARGE (charge) lamp is not lit.

•Charging the battery pack is completed.•The battery pack is not properly installed. c Install it properly (p. 15).

You cannot charge the battery pack. • The POWER switch is not set to OFF (CHG).cSet it to OFF (CHG) (p. 16).

The power runs out quickly, even though the remaining battery time indicator is full.

cCharge the battery pack fully again (p. 16).

While charging the battery pack, the CHARGE (charge) lamp flashes.

•The battery pack is not properly installed. c Install it properly (p. 15).

•Something is wrong with the battery pack.

cIf the symptom persists, disconnect the plug from the wall outlet as soon as possible to cut off the power, and contact your Sony dealer or local authorized Sony service facility.

The buttons do not appear on the touch panel.

•DISPLAY/BATT INFO is pressed. c Press the LCD screen lightly.

c Press DISPLAY/BATT INFO on your camcorder or DISPLAY on the Remote Commander (p. 40).

The buttons on the LCD screen do not work.

cAdjust the screen (CALIBRATION) (p. 204).

Image data cannot be transferred to	• The USB cable was connected before installation of the
your computer via the USB	USB driver was complete.
connection.	c Uninstall the USB driver and reinstall the USB driver
	(p. 148, 153).
	• USB STREAM in	is set to OFF in the menu settings.
	c Set it to ON (p. 180).
The cassette cannot be ejected even if	• Your camcorder is on the point of falling into moisture
the cassette lid is open.	condensation (p. 202).
The cassette cannot be ejected.	c Remove the battery pack, then install it again (p. 15).

190