iControl knobs

The knobs are called the control 1, 2, 3, and 4 knob from the top. These are for adjusting the values of parameters displayed on the right of the display window. The function of each knob depends on the operation software used.

For details, refer to the User’s Guide of the Operation

Software used.

Rear and Side Panels

EXT

PANEL1RS-232CDATA

LAN

 

-AC IN

4DATA LAN connector

5-AC IN connector

3RS-232C connector

2EXT PANEL1 connector

1EXT PANEL2 connector

aEXT PANEL2 (extension panel 2) connector (20-pin, side panel)

For future use. The connector has a power-supply pin (500 mA/5V). Remove the cover if you wish to use this connector.

bEXT PANEL1 (extension panel 1) connector (D-sub, 9-pin)

For future use.

cRS-232C connector (D-sub,9-pin)For maintenance.

dDATA LAN connector (RJ-45,8-pin)Connect to the Ethernet1) switch. The network is configured with PFV-SP-series IF processor and center control panel of the MVS-8000 system connected to the Ethernet switch, which enables communication among connected units. As for the Ethernet switch you can use, consult your Sony representative.

1) Ethernet is a trademark of XEROX Corporation.

For connection with the Ethernet switch, see “System Configuration” on page 31.

For details on the Ethernet switch, refer to the instruction manual of the Ethernet switch.

Caution

When using the DATA LAN connector cable:

For safety, do not connect to the connector for peripheral device wiring that might have excessive voltage.

e- AC IN connector (3-pin)

Connect to a power source of 100 to 240 V AC using a power cord (optional). Be sure to use a power cord that satisfies the regulations of the country in which used.

Location and Function of Controls

33