Turn the jog roller to set the value.
Press the jog roller to select an item to be changed.

4 Press the select R button when you are finished making adjustments.

The adjusted values are stored.

To cancel an adjusted value, press the select L button.

• LCD Brightness

Adjust the brightness of the display window in seven steps. The default setting is “3”. You can adjust the brightness referring to the Sample shown at the bottom of the screen.

• F-KEY LED Brightness

Adjust the brightness of the function buttons in seven steps. The default setting is “5” (brightest). You can adjust the brightness referring to the Sample shown at the bottom of the screen.

• Sound Control

Adjust the sound level of the touch-panel beep. The default setting is “3.” When the sound level is changed, Sound Test is executed.

• Sound Test

Displays “Now testing of sound” while the sound level is adjusted with Sound Control.

• TouchEngine Force: ON/HIGH

Adjust the sensitivity of the TouchEngine in four levels, OFF, ON/LOW, ON/MIDDLE, and ON/HIGH.

•Touch Beep Control Enable/disable the touch-panel beep.

Adjust Time

Set the date and time. The set date and time are retained in memory for about 7 days even if the power is turned off.

1 Press the jog L or R button to select the digit to be adjusted.

2 Turn the jog roller to set the value.

3 Press the select R button when setting is completed.

The adjusted values are stored.

To cancel the adjustment, press the select L button.

Set TCP/IP Config.

The IP Address, Netmask, Gateway, and DNS have been set at the factory, but you can change them as required.

1

2 Press the jog L or R button to select the digit to be changed.

3

4 Press the select R button when you are finished settings.

The set values are stored.

5 Press the select R button to reflect the settings.

The system is rebooted.

To cancel the set values, press the select L button. To retrieve the default settings, select Default.

Calibrating the Touch Panel

Push the center of the crosshairs displayed in the four corners on the touch panel in order with a pen or fingertip. The relationship between the screen and touched position is calibrated.

To calibrate from the beginning again, push some place apart from the crosshairs on the touch panel until the crosshairs appear in the upper-left corner. Then the previous operation is canceled, and you can start the calibration from the beginning.

Scribble Test

You can check the operation status of the touch panel by scribbling. Scribble on the screen with a pen, and the trace will be shown.

Self Diagnosis

The operation of the jog roller, jog buttons, function buttons, and control knobs can be checked.

System Setup 37