Terminating the UCP-8060

Before turning off the UCP-8060, perform the procedures below to terminate the system.

1 Press the select L button (Menu) on the Main Screen.

The Menu display appears.

2 Turn the jog roller to select Shutdown.

3 Push the jog roller.

The Shutdown display appears, and the shutdown process completes.

Note

Do not turn the UCP-8060 off before the Shutdown display appears.

To cancel the shutdown process

Press the select L button (Back).

To perform soft reset

Press the select R button (Reboot).

To start the BIOS Utility

Press the select R button (Reboot) while holding the function 1 button pressed until the function 1 button lights. Then release the button.

To start UPDATE Utility

Press the select R button (Reboot) while holding the function 2 button pressed until the function 2 button lights. Then release the button.

Confirming of the Basic Information

Press the select L and R buttons while holding the function 1 button pressed for more than 3 seconds until the function 1 button lights. Then release the buttons.

The Basic Information of System [BIOS] Utility appears on the screen to show the FPGA version, MAC address, etc.

You can start the BIOS Utility from the Shutdown display.

For details, see “Terminating the UCP-8060” on page 35.

Basic Information of System [BIOS] UTILITY

Version : xxxBulid date : xxx xx xxxx xx:xx:xx

FPGA Revosopm : xxx memorystick host controller : xxx

MAC Address : 08:00:46:xx:xx:xx

IP Address : 10.129.7.1

Netmask : 255.192.0.0

Gateway : 10.128.0.0

DNS : 0.0.0.0

MEMORY SIZE : xxMByte

Reboot

Memory Stick Format

Retrieving the Main Screen

Press the select L button (Reboot).

Setting the Auto Start

If the Auto Start function has been set with the operation software, the top page of the operation software automatically appears after the Main Screen of the UCP- 8060 appears when the power is supplied to the unit.

Setting the Auto Start

To set the Auto Start function, follow the procedures below.

1 Select the operation software to which the Auto Start function is to be set on the Main Screen.

2 Press the select L button (Menu).

The Menu display appears.

3 Select Auto Start.

The Auto Start display appears.

Auto Start

ON

OFF

Exit

Save

4 Select ON.

5 Press the select R button (Save).

The Menu display appears.

Basic Operations 35