Installation of the Operation Software

The UCP-8060 is shipped with the operation software for several products installed. If you wish to use another product, install the operation software for the product following the procedures below. It is also necessary to install operation software when you update the system files.

You can install the operation software using a Memory Stick or via the Internet (HTTP server).

To obtain the operation software, consult your Sony representative..

Note

The memory capacity to store the operation software is limited. You may remove some operation software when you intend to install a new software.

For details on the capacity of a Memory Stick, see “Checking the Information” on page 43.

For details on removing software, see “Removing the Operation Software” on page 42.

Requirements

•Computer (to enable copying files to a Memory Stick if a Memory Stick is to be used)

•Operation software to be installed (two files, with the extensions “jar” and “jad”)

Installation using a Memory Stick

• Memory Stick

Preparations

1 Copy the operation software to a Memory Stick or to an HTTP server using a computer.

To copy onto a Memory Stick, prepare a folder named MSSONY/PRO/UCP, and copy to a folder under UCP.

When you format the Memory Stick on this machine, the MSSONY/PRO/UCP folder is automatically created.

Note

If the filename or folder name has any non-ASCII characters, installation may fail.

2 Turn the UCP-8060 on.

The Main Screen appears.

For details on the IP address of the HTTP server and the network connection, consult your network administrator.

Installation

Installing using a Memory Stick

1 Insert the Memory Stick in which the operation software has been copied into the Memory Stick slot.

2 Press the select L button (Menu).

The Menu display appears.

3 Select Install Settings by turning the jog roller, and press the select R button (Enter).

The Install Settings display appears.

4 Select Memory Stick by turning the jog roller, and press the select R button (Save).

The Menu display appears.

The procedures below depend on whether operation software has been installed or not.

If the operation software has been installed

1 Select Install with the jog roller.

2 Press the select R button (Enter).

The Install display appears. Check that a file with the extension “jad” in the Memory Stick is displayed.

If the file name includes both upper- and lowercase letters, installation is performed normally.

3 Select the operation software to be installed by turning the jog roller, then press the select R button (Go).

Information on the operation software appears.

4 If the displayed information is correct, press the select R button (Yes).

Installation begins. While reading and writing data, the status indicator is lit or blinking.

When installation is complete, a message to indicate this appears on the screen.

Note

While reading and writing data, never turn the power of the UCP-8060 off, or remove the installed Memory Stick. The file may be damaged.

38 Installation of the Operation Software