2 Press the OPEN/CLOSE button to open the paper door.

Started Getting

3 Place the printing paper roll on the tray.

Using UPP-210SE/210HD

Remove label and pull out 15 to 20 cm (about 6 to 8 inches).

Place the paper with the heat sensitive side facing up. The printer will not print if the paper is reversed.

Using UPT-210BL thermal film

*Cannot be used with the UP-970AD. Doing so may cause a malfunction.

Correctly Inserted

Remove label and pull out 15 to 20 cm (about 6 to 8 inches).

Incorrectly Inserted

Place the paper with the heat sensitive side facing up. The printer will not print if the paper is reversed.

4 Insert the paper into the groove of the paper tray and pull it out through the paper exit.

Note

Place the paper near the center of the groove of the paper tray (inside of the guide). Note that paper jams may occur if the paper is placed at the edge of the groove of the paper tray.

Note

Pull out the printing paper to remove any slack and possible creases.

5 Press the OPEN/CLOSE button to close the paper door.

You can also push the paper door to close it.

6 Remove paper leading edge.

UP-990AD

After loading paper, press the FEED button to feed out 15 to 20 cm (6 to 8 inches) of paper and press the CUT button to remove it.

FEED Button

CUT Button

15 to 20 cm

10 Loading Paper in the Unit