Started Getting

FRECEIVING lamp

Lights when the printer receives print data from a PC.

G CUT button (page 22, 33)

Press to cut the completed print using the internal paper cutter.

HFEED button (page 10, 22, 33)

Hold down to feed paper. While a print job is in progress, press to cancel the print job.

ICAPTURE button (page 23)

In the multi-picture mode, press to store the print image in memory.

This function is not available in the single-picture mode.

Note

This function is available only in the analog mode.

JCOPY button (page 24)

In the multi-picture mode, use this button to print images stored in memory (with the CAPTURE button) side by side on a single sheet.

In the single-picture mode, press to print another copy of the last printed image.

In either mode, press once to print only the number of prints set in the “QTY” menu.

KPRINT button

Prints the image currently displayed on the video monitor. The image displayed when you press the PRINT button is stored in memory.

Note

This function is available only in the analog mode.

LOPEN/CLOSE button (page 10, 22, 33) Press to open or close the paper door. While a print job is in progress, press to cancel the print job.

MPaper door

Open to install and replace printing paper, and to clean the head and platen roller. Use the OPEN/ CLOSE button to open or close the paper door.

Rear Panel

A Equipotential terminal

Used to connect to the equipotential plug to bring the various parts of a system to the same potential. Refer to “Important safeguards/notices for use in the medical environments” on page 2.

Bt VIDEO IN (input) connector (BNC type) Connect to the video output connector of the video equipment.

CT VIDEO OUT (output) connector (BNC type) Connect to the video input connector of the video monitor. The output signal depends on the setting of the “VIDEO” item of the menu.

D75 Ω select switch

ON: When nothing is connected to the VIDEO OUT connector, set the switch to this position. OFF: When a video monitor or other video equipment is connected to the VIDEO OUT connector, set the switch to this position.

EANALOG/DIGITAL switch

Press to switch between analog and digital modes. Turn the printer off before switching.

FREMOTE connector (page 12) Connects the RM-91 remote control unit for controlling print operation from a distance.

GUSB Cable Clamper

Holds and secures the USB cable connected to the USB port.

H USB connector (4-pin connector)

Use the supplied USB cable to connect a PC with a USB (USB 2.0 compliant) interface to this connector.

6 Location and Function of Parts and Controls