Printing

Before Starting a Print Job

Always check the following points:

•Unit connected correctly? (page 26)

•Paper loaded correctly? (page 9)

•Menu settings and menu adjustments done correctly? (page 26)

Starting a Print Job

You can set up the printing direction, image size, all sorts of settings for printing, using the menu. This section describes operations after completing all sorts of settings using the menu.

1 Press the power ON/OFF switch to turn the unit on. The back light on the LCD lights in green, and “READY” is displayed on the LCD.

LCD

2 Print the image using the application software.

When the message is displayed on the LCD

If a problem occurs, the back light on the LCD lights in umber and the error message stating the problem is displayed on the LCD.

Message

Cause and remedy

EMPTY

Paper is not loaded. Load paper.

 

 

DOOR

The paper door is open. Close the

 

paper door.

 

 

When the unit stops printing during printing When printing almost black images continuously, the thermal head protection circuit may shut down the unit to prevent the thermal head from overheating. In such a case, the message “COOL” is displayed on the LCD. Leave the unit until the head cools down and this message disappears.

To cancel a print job in progress

To cancel a print job in progress, press the OPEN/ CLOSE button, FEED button or CUT button.

To feed paper

To feed paper, press the FEED button. The unit will continue to feed paper as long as you hold down the FEED button. Do not attempt to pull paper out of the unit with your hand.

Paper currently selected

You can confirm the paper currently selected on the LCD. The pointer points to the paper currently selected. In the following figure, the currently selected paper is the UPP-210SE paper.

UP-990AD

Indicates the UPP-210SE

Indicates the UPP-210HD

Indicates the UPT-210BL

Note

If “CT:ON” is selected in the “AT.CUT” menu, quickly remove the prints that have been cut. Otherwise, the cut prints may block the paper exit and cause a paper jam to occur.

UP-970AD

Indicates the UPP-210SE

Indicates the UPP-210HD

Making Copies of the Last Printout

Press the COPY button. The unit makes a copy of the last printout. Each press of the COPY button prints the number of images set in the “QTY” menu.

Note

If you press the COPY button immediately after turning the power on, the alarm buzzer will sound as nothing is stored in memory.

Mode Digital

Printing 33