Connecting with a Monitor Equipment (VPL-CS7 only)

This section describes how to connect the projector to a monitor equipment.

For more information, refer to the instruction manuals of the equipment you are connecting.

Left side

AUDIO VIDEO S VIDEO

INPUT A

OUT

Monitor cable (not supplied)

HD D-sub 15-pin (male) ↔ HD D-sub 15-pin (male)

to monitor input

Monitor equipment

*This projector is not guaranteed for connecting more than 2 monitors in loop- through connection.

Projecting

INPUT

TILT

MENU

PUSH

ENTER

ON/STANDBY indicators

Remote control

8

Picture the Projecting

detector

 

1 Plug the AC power cord into a wall outlet, then connect all equipment.

The ON/STANDBY indicator lights in red and the projector goes into standby mode.

2 Press the I / 1 key.

The ON/STANDBY indicator lights in green and the Intelligent Auto-setup starts. The lens protector opens, and the powered tilt adjuster rises and stops at the previously adjusted position.

3 Turn on the equipment connected to the projector.

Projecting 19