Note

To connect a Macintosh computer equipped with video output connector of a type having two rows of pins, use a commercially available plug adaptor.

Connecting with a VCR

This section describes how to connect the projector to a VCR.

For more information, refer to the instruction manuals of the equipment you are connecting.

To connect to a video or S video output connector

Ex. VPL-CS7

Left side

AUDIO

VIDEO S VIDEO

INPUT A

MONITOR OUT

1 2 3

to audio

to video

to S video

output

output

output

VCR

1Stereo audio connecting cable (not supplied) (Use a no-resistance cable)

2Video cable (not supplied) or

3S-Video cable (not supplied)

18 Connecting the Projector

To connect to a video GBR/ component output connector

Ex. VPL-ES2

Left side

VIDEO S VIDEO

 

INPUT A

PR

PB/CB

Y

3

2

1

to

 

to RGB/

 

component

audio

 

output

 

output

15k RGB/Component equipment

1SMF-402 Signal Cable (not supplied)

HD D-sub 15-pin (male) y 3 × phono plug or

2Component video (3 × phono plug y 3 × phono plug (not supplied) (Use a 75 Ω coaxial cable) (VPL-ES2 only))

3Stereo audio connecting cable (not supplied) (Use a no-resistance cable)

Notes

•Set the aspect ratio using “Wide Mode” in the INPUT SETTING menu according to the input signal.

•When you connect the INPUT A connector on the unit to a video GBR output connector, select “Video GBR,” or when you connect it to a component output connector, select “component” with the “Input-A Signal Sel.” setting in the SET SETTING menu. The input selection must be performed before inputting the signal.

•Use the composite sync signal when you input the external sync signal from video GBR/component equipment.