on the room temperature or the screen angle. In this case, adjust it manually. Press the D KEYSTONE key on the Remote Commander until “V Keystone” appears on the screen, and adjust the value with the v/V/v/B key. The corrected value is effective until the power turn off.

•Be careful not to let the projector down on your fingers.

•Do not push hard on the top of the projector with the powered tilt adjuster out. It may be occurred malfunction.

7 Turn the zoom ring to adjust the size of the picture.

8 Turn the focus ring to adjust the focus.

AttentionLooking into the lens when projecting may cause injury to your eyes.

Turning Off the

Power

1 Press the I / 1 key.

“POWER OFF? Please press I / 1 key again.” appears to confirm that you want to turn off the power.

Note

A message disappears if you press any key except the I / 1 key, or if you do not press any key for five seconds.

2 Press the I / 1 key again.

The powered tilt adjuster is put away in the projector and the lens protector closes. The ON/STANDBY indicator flashes in green and the fan continues to run for about 70 seconds (VPL-CS7)/for about 90 seconds (VPL-ES2) to reduce the internal heat. Also, the ON/ STANDBY indicator flashes quickly for the first 60 seconds. During this time, you will not be able to light up again the ON/STANDBY indicator with the I / 1 key.

3 Unplug the AC power cord from the wall outlet after the fan has stopped running and the ON/STANDBY indicator has light in red.

When you cannot confirm the on- screen message

When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / 1 key for about two seconds.

Picture the Projecting

Turning Off the Power 21