Notes on InstallationUnsuitable Installation

Do not install the projector in the following situations. These installations may cause malfunction or damage to the projector.

Poorly ventilated

•Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies) that may block the ventilation holes. When the internal heat builds up due to the block-up, the temperature sensor will function with the message “High temp.! Lamp off in 1 min.” The power will be turned off automatically after one minute.

•Leave space of more than 30 cm (11 7/8 inches) around the unit.

•Be careful that the ventilation holes may inhale tininess such as a piece of paper.

Highly heated and humid

•Avoid installing the unit in a location where the temperature or humidity is very high, or temperature is very low.

•To avoid moisture condensation, do not install the unit in a location where the temperature may rise rapidly.

Very dusty

Avoid installing the unit in a location where there is a lot of dust; otherwise, the air filter will be obstructed. The dust blocking the air

through the filter may cause raising the

 

 

internal heat of the projector. Clean it up

 

Overview

periodically.

 

Unsuitable Conditions

Do not use the projector under the following conditions.

Toppling the unit

Avoid using as the unit topples over on its side. It may cause malfunction.

Tilting the unit out of the range of the adjuster setting

Avoid using when the unit is tilted out of the range of the adjuster setting. Such installation may cause color shading or shorten excessively the lamp life.

Notes on Installation 7 GB