Location and Function of ControlsTop/Front/Left SideRear/Right Side/Bottom

 

0

4

 

5

qa

 

 

qs

6

qd

7

 

8

qf

 

9

qg

1Control panel

For details, see “Control Panel” on page 11.

2Lens protector (lens cover)

The lens protector automatically opens when the power is turned on.

3Ventilation holes (exhaust)4Remote control detector5Adjuster (hind pad)

Turn the adjuster to the right or left for minor tilt adjustment of the projected picture.

6Ventilation holes (intake)/Lamp cover7Ventilation holes (intake)/air filter cover

Notes

•Do not place anything near the ventilation holes as it may cause internal heat build-up.

•Do not place your hand or objects near the ventilation holes as it may cause the air coming out heat build- up.

•To maintain optimal performance, clean the air filter every 500 hours.

For details, see “Cleaning the Air Filter” on page 41.

8Ventilation holes (intake)9Powered tilt adjuster0IndicatorsPOWER SAVING

Lights up when the projector is in power saving mode. When “Power Saving” in the SET SETTING menu is set to “ON,” the projector goes into power saving mode if no signal is input for 10 minutes. Although the lamp goes out, the cooling fan keeps running. The power saving mode is canceled when a signal is input or any key is pressed. In power saving mode, any key does not function for the first 60 seconds after the lamp goes out.

TEMP (Temperature)/FAN

Lights up or flashes under the following conditions:

–Lights up when temperature inside the projector becomes unusually high.

–Fashes when the fan is broken.

For details on the TEMP/FAN indicator, see page 44.

LAMP/COVER

Lights up or flashes under the following conditions:

–Lights up when the lamp has reached the end of its life or becomes a high temperature.

GB 10 Location and Function of Controls