INPUT-A:Selects video signal input from the INPUT A connector.

INPUT-B:Selects video signal input from the INPUT B connector.

INPUT-C:Selects to display the Windows CE window.

VIDEO: Selects video signal input from the VIDEO (VIDEO IN) jack.

S-VIDEO:Selects video signal input from the S VIDEO (VIDEO IN) jack.

4 Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display “LENS FOCUS.” Then press the arrow keys to adjust.

5 Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display “LENS ZOOM.” Then press the arrow keys to adjust.

6 Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display “LENS FOCUS.” Then press the arrow keys to adjust again.

7 Press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display “LENS SHIFT.” Then press the arrow keys to adjust.

Note on focus and zoom adjustments

If the optional VPLL-ZM101, VPLL-ZM31 or VPLL- FM21 lens is installed, perform the focus and zoom adjustments manually.

Note

Looking into the lens when projecting may cause injury to your eyes.

Cut off the picture

Press the PIC MUTING key on the Remote Commander. To restore the picture, press the PIC MUTING key again.

To get the clearest picture

You can get the suitable picture when a signal from the computer is input. Press the APA key.

The picture is automatically adjusted to be projected clearest.

Projecting

Notes

•Adjust the signal when the still picture is displayed on the screen.

•Press the APA key when the full image is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen.

•If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture.

•“ADJUSTING” appears on the screen. To restore the original screen, press the APA key again during the adjustment.

•“Complete!” appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals.

•Adjust the items in the INPUT SETTING menu when you adjust the picture manually.

For details, see page 23 (GB).

To correct the trapezoid

When the projecting image is a trapezoid, press the LNES key on the Remote Commander or LENS CONTROL key on the control panel repeatedly to display “LENS SHIFT.” Then press the arrow keys to adjust.

If the image is still a trapezoid, correct it in DIGIT KEYSTONE in the INSTALL SETTING menu.

When the base edge is longer than the upper edge as shown in the figure below:

Set the value to negative.

When the upper edge is longer than the base edge as shown in the figure below:

Set the value to positive.

For details on “DIGIT KEYSTONE,” see page 27 (GB).

19 (GB)