
Using the MENU
The projector is equipped with an
Note
Before operation, confirm that the PJ/NETWORK select switch on the Remote Commander is set to PJ. If it is set to NETWORK, the menu display will not appear even when you press the MENU key on the Remote Commander.
To select the language used in the menu, see page 26 (GB).
1 Press the MENU key.
The menu display appears.
The menu presently selected is shown as a yellow button.
PICTURE CTRL | |
CONTRAST: | 80 |
BRIGHT: | 50 |
RGB ENHANCER: 30 | |
GAMMA MODE: GRAPHICS | |
COLOR TEMP: LOW |
2 Use the M or m key to select a menu, then press the , or ENTER key.
The selected menu appears.
Menus | Setting items | |||
|
|
|
|
|
|
|
|
|
|
| SET SETTING |
|
|
STATUS: ON
AUTO INPUT SEL: OFF
LANGUAGE: ENGLISH
POWER SAVING: OFF
IR RECEIVER: FRONT&REAR
3 Select an item.
Use the M or m key to select the item, then press the , or ENTER key.
4 Make setting or adjustment on an item.
For details on setting individual items, see the relevant menu pages.
Using the MENU
To clear the menu
Press the MENU key.
The menu display disappears automatically if no key is pressed for one minute.
To reset items that have been adjusted
Press the RESET key.
“Complete!” appears on the screen and the settings appearing on the screen will be reset to their factory preset values.
Items that can be reset are:
•“CONTRAST”, “BRIGHT”, “COLOR”, “HUE”, “SHARP” and “RGB ENHANCER” in the PICTURE CTRL menu.
•“DOT PHASE”, “SIZE H” and “SHIFT” in the INPUT SETTING menu.
•“DIGIT KEYSTONE” in the INSTALL SETTING menu.
About the memory of the settings
The settings are automatically stored in the projector memory.
When no signal is input
When there is no input signal, “NO
About the menu display
You can set the display position of the menu, intensity of the background picture and tone of the menu items as you like.
For details, see page 27 (GB).
21 (GB)