DIGIT KEYSTONE

Corrects the trapezoid caused by the projection angle. If the base edge is longer, set a negative value; if the upper edge is longer, set a positive value to square the image.

INSTALLATION

Sets to reverse the picture horizontally or vertically.

FLOOR-FRONT:The picture is not reversed.

CEILING-FRONT: The picture is reversed horizontally and vertically.

FLOOR-REAR:The picture is reversed horizontally.

CEILING-REAR:The picture is reversed vertically.

Note

In case of using a mirror, be careful of installation since the picture may be reversed.

LENS CONTROL

When set to OFF, the LENS FOCUS, ZOOM and SHIFT keys do not function.

MENU POSITION

Selects the display position of the menu from TOP LEFT, BOTTOM LEFT, CENTER, TOP RIGHT and

BOTTOM RIGHT.

MENU COLOR

Selects the tone of the menu display from STANDARD, WARM, COOL, GREEN or GRAY.

The INSTALL SETTING Menu

MENU BACKGRND

Selects the intensity of the background picture of the menu display from DARK, STANDARD or LIGHT.

INPUT-C FUNC.

Set to ON when using the Network function.

Note

Be sure to exit every application software that is open before you switch the setting ON to OFF. Otherwise, system down may occur and you may not restart the projector.

LAMP MODE

Sets the lamp brightness in the projection. STANDARD: Reduces fan noise and power

consumption.

HIGH: The picture is bright.

If the LAMP MODE is set to STANDARD, the next time the power is turned on, the lamp will use the HIGH setting for the first 3 minutes, and then go to

STANDARD.

Compared with the STANDARD setting, the brightness of an image projecting under the HIGH setting will be high.

DIRECT PWR ON

Selects the power condition of the unit when the power is supplied.

ON: When the power is supplied, the unit is turned on.

OFF: When the power is supplied, the unit is set to standby mode.

LAMP TIMER

Indicates how long the lamp has been turned on.

Note

This only displays the time. You cannot alter the display.

27 (GB)