Sony VPL-FX51 Connector panel, 4-pin):, RS-232C, S VIDEO (mini DIN, VIDEO (BNC type):, VIDEO (BNC type):, 5VIDEO IN connectors, 9VIDEO OUT connectors

Location and Function of Controls

Connector panel

Front

2 3	4		5 67

							TRIG	PLUG IN POWER
			INPUT B				TRIG	CONTROLS
			INPUT B	INPUT C
			RGB (DVI)	INPUT C	VIDEO IN
			RGB (DVI)	ETHER	VIDEO IN
INPUT A				ETHER
INPUT A	G/Y	B/B-Y/PBSYNC/HD	VD				RS-232C
R/R-Y/PR	G/Y	B/B-Y/PBSYNC/HD	VD		S VIDEO	VIDEO	RS-232C
				MONITOR OUT	VIDEO OUT

1			9	8
	0

1INPUT A 5BNC connectors (R/R-Y/PR, G/Y, B/ B-Y/PB, SYNC/HD, VD connectors) (BNC type) Connect to a high-resolution computer or VCR where signals are transmitted long distances; for example, when the projector is installed on the ceiling. According to the connected equipment, computer, component (R-Y/Y/B-Y), HDTV or DTV signal is selected.

2INPUT B RGB (DVI) connector

Connect to equipment equipped with the DVI output (digital or analog RGB) using a commercially available DVI cable.

3INPUT C PC CARD slot (Type II)

A wireless LAN PC card or PC memory card can be attached according to your requirement.

For details, see “Installing a PC card” on page 16 (GB).

4INPUT C ETHER connector (10BASE-T/ 100BASE-TX)

Connect to a computer on the same LAN with the LAN cable when you use the networking function of this projector.

5VIDEO IN connectors

Connect to external video equipment such as a VCR. S VIDEO (mini DIN 4-pin):Connects to the S video

output (Y/C video output) on video equipment. VIDEO (BNC type): Connects to the composite

video output.

6TRIG (trigger output) jack (monaural minijack)

The signal is transmitted from this jack to the connected equipment whether the projector is on or off. (This is not a power source for external equipment.) Approximately 12 V DC signal is output when the projector power is on. The signal is 0 volt level output when the projector power is off.

7CONTROL S/PLUG IN POWER (DC 5V output) jack (stereo minijack)

Connects to the control S out jacks of the Sony equipment. Connects to the CONTROL S OUT jack on the supplied Remote Commander when using it as a wired Remote Commander. In this case, you do not need to install the batteries in the Remote Commander, since the power is supplied from this jack.

8RS-232C connector (D-sub 9-pin, female) Connects to a computer to operate the projector from the computer.

9VIDEO OUT connectors

S VIDEO (mini DIN 4-pin): Used as loop-through output via the S VIDEO IN connector.

VIDEO (BNC type): Used as loop-through output via the VIDEO IN connector.

q; MONITOR OUT connector (HD D-sub 15-pin, female)

Connects to the monitor input connector on the monitor. Outputs signals from the selected channel in the INPUT A (5BNC) or INPUT B (DVI) connector. This connector does not output any signals from the DVI connector if the input signal is digital.

12 (GB)