The SET SETTING Menu
The SET SETTING menu is used for changing the settings of the projector.
SET SETTING | Input A |
Smar t APA: | On |
Auto Input Search: | Off |
Computer | |
Color System: | Auto |
Power Saving: | Off |
IR Receiver: | Front&Rear |
Menu Items
Smart APA
Activates or deactivates the Smart APA1).
On: Normally select this setting. When a signal is input from a computer, the APA functions automatically so that the picture can be seen clearly. Once the specified analog input signal has been adjusted by the Smart APA, it will not be readjusted even when the cable is disconnected and connected again or the input channel is changed. You can adjust the picture by pressing APA key on the Remote Commander even if the Smart APA set to “On.”
Off: The APA functions when you press the APA key on the Remote Commander.
1)The APA (Auto Pixel Alignment) automatically adjusts “Dot Phase,” “H Size” and “Shift” in the INPUT SETTING menu for the input signal from a computer.
Auto Input Search
Normally set to “Off.”
When set to “On,” the projector detects input signals in the following sequence:
Input-C Signal Sel.
Selects either a computer signal, a component signal or a video GBR signal (15k RGB, DTV, HDTV) for the signal that is input to the INPUT C connector.
Color System
Selects the color system of the input signal. If you select “Auto,” the projector detects the color system of the input signal automatically. If the picture is distorted or colorless, select the color system according to the input signal.
Power Saving
When set to “On,” the projector goes into power saving mode if you do not operate the unit for 10 minutes with no signal input.
IR Receiver
Selects the remote control detectors (IR receiver) on the front and rear of the projector.
Front&Rear: Activates both the front and rear detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only.
34 The SET SETTING Menu